2.5” SATA III Prime Series 6GBps, 2TB, 4TB, 8TB SSD

Redefining Flash Storage from the inside out

2.5” SATA III Prime Series 6GBps SSD• SATA 6.0Gbps host interface
• Breakthrough capacity and scalability – up to 8TB SSD in 2.5” form factor with a single SSD controller
• Revolutionary HyperLink NAND (HLNAND) technology – no practical limit on number of devices per channel with ring architecture
• Excellent performance – point‐to‐point connection provides excellent signal integrity 540MB/s for sequential Read/Write, up to 100K/90K IOPS for random Read/Write
• Low power – single controller, low voltage IO, un‐terminated bus, data truncation, hierarchical MCP
• Reduced system cost – single controller, small footprint, reduced networking infrastructure – low Total Cost of Ownership (TCO)
• Ultimate reliability
    • Operating Temperature: 0°C to 70°C
    • Optimized for wide temperature operation from ‐40°C to 85°C
• Full End‐to‐End Data Protection‐with advanced error correction scheme and in‐transit data protection
• Ultra‐high capacity solid storage solution for various rugged and mission critical application
• Supported sector size: 512 Bytes
• Hardware‐based 256‐byte encryption Advanced Encryption Standard (AES) technology
• Self‐encrypting models conform to TCG Opal 2.0 specification
• Hot‐pluggable removal and insertion providing in‐service replacement options
• Enhanced Power Loss Data Protection – securing data responded to host with internal power back‐up solution
• Power and thermal throttling – auto peak power control by monitoring on‐board temperature sensor
• 4TB/8TB capacity available in 7mm/15mm z‐heights for space‐constrained applications
• ECC, Wear Leveling, Bad Block Management, TRIM, SMART, NCQ
• MLC/SLC

Specifications 2.5” (7.0mm z‐Height) 2.5” (15.0mm z‐Height)
Capacity 2TB1 4TB1 8TB1
Part Number AMP25TT20‐HM(S)5U9I AMP25TT40‐HM(S)5U9I AMP25TT80‐HM5U5I
Interface SATA 6Gb/S
NAND Flash Type MLC/SLC MLC
Performance3
Seq. Read/Write 128KB (MB/s) Up to 540 / 540
Random Read/Write 4KB (IOPS) Up to 100K / 90K
Avg. Latency Read/Write 65μs/40μs
Reliability
UBER 1 in 1018
MTBF2 2,000,000 hours
Data Integrity End‐to‐End Data Protection
Lifetime Endurance4 900 TBW1 1,900 TBW1 3,900 TBW1
Warranty 3 years
Encryption AES‐256 Full Disk Encryption, TCG Opal 2.0
Power & Environmental
Power consumption (Active/Idle) TBD
Operating Temperature ‐40 to 85°C
Non‐Operating Temperature ‐55 to 95°C
Shock (G/0.5msec) 1500
Physical
Depth x Width x Height 100.45mm x 69.85mm x 7.0mm 100.45mm x 69.85mm x 15.0mm
Weight 78g 88g 165g

Note:
    1. One gigabyte (GB) is equal to one billion bytes, one terabyte (TB) equals 1,000GB (one trillion bytes), when referring to hard drive or solid state drive capacity. Accessible capacity will vary from the stated capacity due to formatting and partitioning of the drive, the computer’s operating system, and other factors.
4TB SLC height=15.0mm
    2. MTBF target is based on a sample population and is estimated by statistical measurements and acceleration algorithms under nominal operating conditions. MTBF ratings are not intended to predict an individual drive’s reliability. MTBF does not constitute a warranty.
    3. Based on internal testing, performance may be lower depending upon host device, OS and application.
    4. Based on JESD218 standard with JESD219 workload.